Home Marmoset

Cage is broken on 2 small sections

guitarguy00
polycounter lvl 7
Offline / Send Message
guitarguy00 polycounter lvl 7

Hey there guys, I have come across this issue when i try and bake this one mesh.

I have cut seams where all the hard angles are and have set smoothing groups to all the shells. This error does not occur at the bottom where there is a similar shape for some reason. There are no double verts/edges to be found either.



Any help would be much appreciated.

Replies

  • EarthQuake

    This sort of thing can happen with extreme changes in normals (over 90 degrees), try beveling the edge in question.

    Be sure you're baking and that this causes a problem as well - the cage display is for visualization purposes only and may not indicate an error or problem.

  • guitarguy00
    Offline / Send Message
    guitarguy00 polycounter lvl 7

    Ahh I see, thanks for that. I will try a bevel there. I did make a seam and harden that edge but the cage still breaks. There is a tiny shading flaw there that doesn't exist on the lower half of the mesh for some reason. Probably won't even be noticeable as this is a hammer on a flare gun so it is a tiny part of the whole model.

Sign In or Register to comment.