AO map not displaying in Marmoset Toolbag 3

Danface

Hey, 

I had this issue a while back and managed to figure it out but I haven't touched it in a while and cannot for the life of me remember.

My AO map isn't displaying in toolbag when imported in. I remember there was something I ticked or enabled something which allowed it to show but I've tried clicking everything and nothing seems to work.

The image is showing the AO turned on on the left and off on the right (it looks like the same image because it basically is )

Danface

I solved it  

For anyone else having this problem, you need to put your AO map into the cavity map section

Obscura

Now, I'm not a Toolbag master, so I can't tell you if its broken or not, but logically, ao should show only in indirect lighting, so shining on a surface with a light and expecting ao doesn't make much sense. Increase the indirect lighting a little bit (skylight), and notice that the ao map shows in the shadows, even when its plugged into the ao material slot.

CrackRockSteady

Obscura is correct.  You shouldn't need to put your AO map in the Cavity map slot...that's for a Cavity map.  AO map goes in the Occlusion slot.