Its been a while since I last used SD and I could appreciate some advice...

oraeles77

n a w

I know I could have easily used the transform 2d thing to make that hp model! anyway some suggestions would be welcome.

Mink

Did you make sure your high poly was in the same location? In blendee hit ctrl+G location, then set that to 000 for both objects.

poopipe

If the meshes are in the same place and normals are pointing in the right directions then try increasing projection distances when baking

oraeles77

Mink said:

Did you make sure your high poly was in the same location? In blendee hit ctrl+G location, then set that to 000 for both objects.

of course they are in the same location! thanks.

oraeles77

poopipe said:

If the meshes are in the same place and normals are pointing in the right directions then try increasing projection distances when baking

i will give that a try.