Fibermesh more "geometry"?

Mr.Moose

I've googled quite a bit, searched the forms.. I just can't figure out how to add more "geometry" to fibermesh. OR something to give me more control over the form. I can only push and pull so much, and it smooths it on the render. 

As you can see on the above picture his hair flip is very jagged, and I need more control than I am seemingly getting. 

New to fibermesh, so if i'm approaching it wrong just let me know the "proper" way to do it.. Doing my best >.<

Halp.

ETA: I thought maybe I could just sudivide it! "Oh im dumb this is simple!"
Nah, Subdivision breaks Fibermesh ((

CharacterCarl

The only way I know of to add more resolution to the DynaMesh strands is by using the "segments" slider when creating them:

Mr.Moose

Ah thank you! I totally over looked that... Not sure how I didn't see! Thank you again!