Exporting from ZBrush for 3D Printing.

Lulorz

Hi there.

I'm getting a model 3D printed, and I need to make the model a single piece of geometry. Previously I simply merged all the subtools and exported as an .obj, but when I ran a density checker on Sculpteo.com, areas of my model were deemed too thin as if they were still seperated, despite overlapping and intersecting each subtool.
I attempted to run Unified Skin over the whole model but the resolution was simply not high enough. Can anyone help?

Kot_Leopold

Have you tried Dynamesh?

Lulorz

I'm going to make an attempt at Dynamesh'ing the whole model, piece by piece together and using a duplicate to project it onto to keep the detail. Fingers crossed.

erroldynamic

Are you making sure that each piece is water tight and capped off?

Lulorz

I dynameshed everything and it worked! Thankyou for reminding me about Dynamesh, for some reason it totally slipped my mind, and yes, every piece is water tight/capped off, made sure of that