Need Help really quickly!
polycounter lvl 8
Ok, so I got a call for a job interview the other day, and part one of the interview is a 3D test. I have to make an object that they chose and of course, after years of doing 3D, I had to come across this problem during the test. I have until tuesday to finish, and today is Friday...and just turned to saturday(hit 12 oclock while i'm typing hahaha).
My problem is, when I export to .obj, it messes my geometry up. I made one whole model and then encountered this at the very end. After searching for hours, I realised I was just burning time, and figured it would save me time in the long run to start a new model from scratch, and what do you know, its happening again.
Heres an example of the newer mesh.
http://s647.photobucket.com/albums/uu192/gannonroader/?action=view¤t=problemo.jpg
For some reason it won't let me post pics.
My problem is, when I export to .obj, it messes my geometry up. I made one whole model and then encountered this at the very end. After searching for hours, I realised I was just burning time, and figured it would save me time in the long run to start a new model from scratch, and what do you know, its happening again.
Heres an example of the newer mesh.
http://s647.photobucket.com/albums/uu192/gannonroader/?action=view¤t=problemo.jpg
For some reason it won't let me post pics.
Replies
You could also try using some of the other .obj export settings/presets if you're on 2009 or higher. Or use the Guruware obj exporter plug-in for lower versions (same thing, was included in 2009 and up).
good luck mate !
I'm using Max 9 for the record.
Triangulating this before export didn't fix it?
I agree with everyone else that you should get the guruware .obj exporter it works a lot better than the max one.
And of course if you haven't already Reset X-Forms because that is the magic fix shit button