3D minotaur model
Hey Guys,
I made this Low Poly model of a Minotaur and I wanted to post it up. I'd gladly appreciate suggestions if you have them. Thanks guys!
I made this Low Poly model of a Minotaur and I wanted to post it up. I'd gladly appreciate suggestions if you have them. Thanks guys!
Replies
good textures
The neck is good and tapers well into his back but just give his jaw a bit more mass and make him look like he could take a swing from a sledgehammer, also i'd thicken his horns a bit especially towards the base. Great model overall well done.
Heres my 2 cents:-
-) Those abs are really unnatural :P
-) You could have done so much more with youre speculars. I see some issues with distinguishing different materials.
I do think you could have handled the triangulisation on the top of the forearm (the brachioradialis) better.its getting 7 edges from all different sides.Ive personally found it better if you have more than 4 edges converging at a single vertex. Id say 5 tops.
Crits:
He's a little wispy.
Arms seem a bit long and thin.
The hooves seem more like camel feet (squishy pads) than cow hooves.
The leg warmers are kind of thick just before the hoof.
@Sicsided, Vig, and Scourgewarper_Thank you guys! I'll totally re-establish his sizes and proportions. I'll tank him up so he can look like he could take a sledgehammer or two.
@butt_Sahib_Thank you. I appreciate your two cents. I'll pay more attention to detail and rework the spec map to bring out some hair strands, leather, and bone.
@ all_ I'll pick this character up again in a week or two because I'm trying to finish up a city that I've been working on for the past few months. It looks like a week or two more till I can give it a green light but before I do that, I'll make sure that I post so I can get some fresh eyes on it.
I agree the fur on the back need to stand out a little more somehow, and maybe sharpen up the skin diffuse in places. (cut on the arm).
good stuff!