Clone and symetrize in Zbrush?

NAIMA · Dec 2013

Hello , I know this is probably a stupid question , but how can I do to Clone and Symmetrize a model I am working on to get the equivalent mirrored on the other side of the z axis as in this image ?

The blue woudl be the cloned part ...

cryrid · Dec 2013

Mirror and weld would be the quickest way as you wouldn't need to worry about the welding due to the gap. If it mirrors the wrong side, use the mirror deform first.

Otherwise, you can split the one half into its own subtool and use subtool master's mirroring options

NAIMA · Dec 2013

SO I first dupocate the subtool and then I apply the deformer?

cryrid · Dec 2013

There's no duplication needed if you're using Mirror and Weld.

NAIMA · Dec 2013

I did check the deformation submenu but I see only Mirror and it doesn't allow me to mirror it keeping the information on the masked parts that I actually wanted to keep , also it asked me to remove lower subd levels ... perhaps I am looking in the wrong section?

NAIMA · Dec 2013

Ok sorry I found that button it under subtools , and seems to indeed to do the right thing but , the axis is too much centered on the object and so turns out a weird welding, I woudl need to put more distant that mirroring plane how can I do that? Btw thanks for the help .

so actually shift the plane of symetry?

cryrid · Dec 2013

Mirror and Weld is under geometry.
The centering will depend on if you're using local symmetry or not. If not, then it uses the world center. You can offest the mesh by using transpose or the Offset deform

Clone and symetrize in Zbrush?

Replies