Workshop # 1- SupRore

Joseph Silverman

I'm not sure my contributions here will be too informative, but hopefully i can at least offer a few educational mistakes.



I dont have much to say for this so far. My modeling is pretty haphazard, I'm very much focused on whatever works over super clean meshflow. That might be a problem, in some places...

Pedro Amorim

dont worry have mesh flow. if the for is ok, the flow is not really important since this is hard surface.

slave_one

lol, SupRore, offering educational mistakes .. I will try to do the same! Just you wait!

Racer445

Not bad so far. The top edges could probably be more round and some edges be soften, but it's pretty good at the moment.

The center button also doesn't look perfectly round.