Rotate wooden wall panels/wall molding/frames transitions in corners

Cirmius

Hi!

The screenshots tells the best whats my problem. I want to merge the corners.

If I I will rotate panels in the corner by the 45 degrees they will narrow. I was looking for some solutions in architect visualization tutorials but couldn't find any (solutions, not films :P).

FrankPolygon

It looks like you're using Blender so you could try a shear operation. Set the pivot point to 3D cursor, snap the 3D cursor to the inside vert on the corner, select the end of the trim piece, set the view port to top down view and run the shear operation.

Another option would be to cut through the mesh using the vertex snapping option, combined with an angle constraint then remove any left over geometry.