Request: Pretty simple papr mask design for 3d printing
Hello there! My modeling skills are terrible, I am trying to create a model of this mask for 3d printing; It will contain some discreet fans, and if viable, some control circuitry with a battery built in.
The middle piece for the nose is not required for a powered air purifying respirator, and would not be included.
I've been working with Onshape, but alas, I have yet to get over the learning curve.
I was hoping to flatten the curve with this mask
My first attempt on Tinkercad was corrupted and ... well, terrible.
The electronics, could be an aduino nano and brushless microcontroller, you can see a duck taping of these items halfway down this page : https://github.com/jcl5m1/ventilator
So if somebody out there is willing, that's the idea!
Thanks,
~Sky
The middle piece for the nose is not required for a powered air purifying respirator, and would not be included.
I've been working with Onshape, but alas, I have yet to get over the learning curve.
I was hoping to flatten the curve with this mask
My first attempt on Tinkercad was corrupted and ... well, terrible.
The electronics, could be an aduino nano and brushless microcontroller, you can see a duck taping of these items halfway down this page : https://github.com/jcl5m1/ventilator
So if somebody out there is willing, that's the idea!
Thanks,
~Sky