Home 3D Art Showcase & Critiques

[WIP] Jester Character For 3D Printing

polycounter lvl 4
Offline / Send Message
Nelagord polycounter lvl 4
Hello everyone. I made a sculpt of a jester (concept from MuYoung Kim).
I'd like to make it 3D printing eligible. Since I don't know much about 3D printing yet and it's my first try at it, I would like some advice on mistakes I have done and where to add details that can still be seen once printed. For reference, the base is to be 25mm wide and I'd like it to be up to the standard of plastic miniatures.

From what I could gather from my own mini, nothing should be less than 1mm thick, and I have kept that in mind for this sculpt.

Here is the concept :

And here is my progress so far :

Thank you for reading.
Sign In or Register to comment.