Normal map seam in a flat plane.

Udjani

Hey.
The seam only apears when seen from an angle, the surface is flat and i have hard edges all around. I tried some things but no luck, any idea if it's possible to get rid of them?

TheGabmeister

Perhaps it has something to do with the UVs? Show us a screenshot of the UV map.

Udjani

TheGabmeister said:

Perhaps it has something to do with the UVs? Show us a screenshot of the UV map.

Those three at the bottom and left. 

TheGabmeister

It's possible that the padding between the problematic seams and the edge of the texture is too small. Try increasing that.

audi100

pretty sure it is caused by the green and red parts at the end of the planes, if you get rid of those it should be fine.

Farfarer

If it's only seen from an angle, it's likely due to mips/filtering which would indicate that it's an issue with padding.

And, yeah, looking at your bake, you'll want to give things a good bit more padding (including between islands and UV bounds, not just between islands) to prevent that happening.

Udjani

It was padding, haven't considered it as a problem since i was using a 2k texture. Thank you guys!