Ferrari Enzo [WIP]
node
Been modelling a Ferrari Enzo I want to use to use in a lighting project.
Cars are pretty standard modelling projects, but I found this one to be more difficult than your average car because
the engine bay shows through the rear window, which forces me to either a) cheap out on the engine bay b) model the engine bay.
Here's my work so far... almost done. All critiques welcome. If it's good, tell me what's good about it. If it sucks... tell me what sucks about it. I'll take everything into consideration. Thanks a lot guys.
Cars are pretty standard modelling projects, but I found this one to be more difficult than your average car because
the engine bay shows through the rear window, which forces me to either a) cheap out on the engine bay b) model the engine bay.
Here's my work so far... almost done. All critiques welcome. If it's good, tell me what's good about it. If it sucks... tell me what sucks about it. I'll take everything into consideration. Thanks a lot guys.
Replies
The circled point seems too pointy and according to the reference i saw the line i curved upwards but not pointy.
Lastly the mirror seems a bit off, i think it needs to be more pointy at the top.
That's it, the rest of the model is amazing!
Keep it goin
I haven't smoothed the model yet so some things will look pointy. I'll post some updates soon. Very close to finished. I'll check out the side mirrors when I get back to it... I did make a mental note about it. Thanks so much for the feedback!