Doom props, need some critics.
interpolator
Hey, those 3 are my frist try to do something without ''copyng'' a mesh, and i need some crits and advises about what would you do and what is wrong etc.
I spoted some errors, some that i yet can't solve, like the bend on the tip of the ''vent/tube'', but i will play more with that this week.
I was always traying to get a good edge flow, and even though i was reusing every edge that i could, i end up using too many i think, and always at the end i have problems with cap, things get pretty confuse, did some questionable things to solve pinching too, but it works.
Also any advice or tip of when/where to model something as a separate piece would help me.
Originals: https://www.artstation.com/artwork/ZJyJZ / https://www.artstation.com/artwork/3aya2
I spoted some errors, some that i yet can't solve, like the bend on the tip of the ''vent/tube'', but i will play more with that this week.
I was always traying to get a good edge flow, and even though i was reusing every edge that i could, i end up using too many i think, and always at the end i have problems with cap, things get pretty confuse, did some questionable things to solve pinching too, but it works.
Also any advice or tip of when/where to model something as a separate piece would help me.
Originals: https://www.artstation.com/artwork/ZJyJZ / https://www.artstation.com/artwork/3aya2