[I Request Feedback] - Dwarft Sculpt to be 3D printed

onewinged · Dec 2016

So this morning I started working on this character (4 ish hours of work). I'm not very experienced when it comes to character sculpting and therefore have a hard time seeing faults. I would like to improve and that is why I'm asking for feedback.
The character was created using ZSpheres. Right now I'm trying to get the form right as well as a nice and readable silhouette. The models currently sits at 29k and will a little bit higher to get the model smooth.

Note that its going to be 3D printed on a Flashforge Finder so fine details in the sculpt will not show up and therefore I'm not going to spend time on it.

Any feedback would be appreciated.

Image: https://us.v-cdn.net/5021068/uploads/editor/9a/egqwgts5jf1g.png

Image: https://us.v-cdn.net/5021068/uploads/editor/kf/3alqtjphuce7.png

Image: https://us.v-cdn.net/5021068/uploads/editor/l7/k9lp8hp8lj4x.png

Image: https://us.v-cdn.net/5021068/uploads/editor/p6/rn99y41yecws.png

Thanks in advance
Tim/onewinged