White seams around border problem...
polycounter lvl 9
I can't figure out what's going on here, I've done this many times before without any problem. I'm using the volume fill option to mask out pieces of my model, unfortunately, I'm getting these white seams around the borders.
Here's what I'm talking about:
I've spit my UV's at 90 degree intervals. I've done this many times in the past this way, no problems.
I'm using SP 1.7.3
Here's what I'm talking about:
I've spit my UV's at 90 degree intervals. I've done this many times in the past this way, no problems.
I'm using SP 1.7.3
Replies
What was happening, Iaccidentally attached a few unnecessary pieces to my fbx file. Their UV's were slightly off, overlapping ever so slightly around the borders.
Merry Christmas.