[Zbrush] Model Opacity bug?
polycounter lvl 10
Hey Polycounters,
I've just stumbled on a very annoying possible bug.
In Zbrush (I've tried 4R7 P2 and P3), trying to decrease the "model opacity" slider from the Texture tab makes my mesh darker instead of transparent.
I've doubled check masking and polypaint but it seems they're not the culprits.
Any clues?
A temporary quick fix I found is by enabling "fill mode 3" from the Draw tab and use "Edge enhance factor" and "Enhance Opacity". Not the same but it does the job.
thanks guys!
I've just stumbled on a very annoying possible bug.
In Zbrush (I've tried 4R7 P2 and P3), trying to decrease the "model opacity" slider from the Texture tab makes my mesh darker instead of transparent.
I've doubled check masking and polypaint but it seems they're not the culprits.
Any clues?
A temporary quick fix I found is by enabling "fill mode 3" from the Draw tab and use "Edge enhance factor" and "Enhance Opacity". Not the same but it does the job.
thanks guys!