Maya 2016 Bevel Offset Error

Ladygrace

I am trying to turn off the bevel "Offset as Fraction" options, but when i do it completely messes up the model completely. I have been unable to find out how to fix this issue and no clue what is causing it.

Left is the Offset as Faction "On" , Right is what happens when i set Offset as Faction "Off"

Any clue or help would be wonderful as it is rather frustrating. 
Thank you

m4dcow

Change the offset amount, you are probably working in relatively small units. When you turn off offset as fraction, the bevel is applied in units you are using. So if your model is relatively small an offset of 0.2 could give you inside out bevels like you have there.

Ladygrace

m4dcow said:

Change the offset amount, you are probably working in relatively small units. When you turn off offset as fraction, the bevel is applied in units you are using. So if your model is relatively small an offset of 0.2 could give you inside out bevels like you have there.

Thank you very much. That was the problem as i forgot about the scale i was using. Thank you again for the help