Hi PC,
I've got a bit of a problem that I've been trying to figure out and seem to be stuck. I'm modeling the outer shell of a cryo pod and I seem to be getting some pinching. I've basically taken a cylinder, cut a hole in it and bevelled the edges and added the supporting loops. The bevels themselves seem fine.
The problem areas that I'm running into seem to be a result of those triangles but I tried extending the support loop further out and still seem to get the pinching. Any ideas on how I should proceed? Not sure if I should be carrying the loops around the cylinder or not.
Please and thank you

Replies
Try to reduce all the poles.