Cylinder Extrusion Subdiv

PetSto

As title say, how to right create extrusion for cylinder with nice subdiv, I play with this some time and results are bad, can somene elp me with this. Thanks.



obj
https://mega.nz/#!tY5h2TAZ!N9Khp3_4RoVWFFUKXbG1v074oNgIQIFSF_dYd7BOGk8

MephistonX

Where do you want to extrude the cylinder from on the mesh ?

Stromberg90

We do have a huge thread for questions like these and answers to questions like these.
http://www.polycount.com/forum/showthread.php?t=56014

PetSto

MephistonX wrote: »

Where do you want to extrude the cylinder from on the mesh ?

I want extrude middle part of cylinder as you can see on image.

Stromberg90 wrote: »

We do have a huge thread for questions like these and answers to questions like these.
http://www.polycount.com/forum/showthread.php?t=56014

Yes, thanks for this, but I check every page and there are lot of interesting shapes, tricks, .. but what I need isnt there. I send new image what I exactly need, I play with this but is possible create this shape with bevels and 2 support loops on every side beveled edge with less geo ? Thanks.



Obj
https://mega.nz/#!lQZnRBLb!n9fkiZdzEMaIn2hfhblugLzPLeV75ze4SwSb94LEvNY

WarrenM

FYI, you'd be better off posting in that mega thread ... that's what it's for. Then other people would stumble over the answer later.

Skumtron

This is how I'd do it:



If you try to do it with less sides, you're going to have hard time keeping everything looking nice and base circular.


Here's the difference between 48 and 24 sided cylinder, both using equal bevel:

PetSto

Thank to everyone, I will rewrite this topic to megathread.