Is this made with an Ultimaker 2? They look like they're made in that molded plaster way, it's such good quality! Ultimaker is FFF/plastic which is quite easy to see cus of the lines or layers which are pretty easy to see up close... Maybe you gave them some love afterwards?
They look great btw Did you need a lot of support structures?
Yep, done on an Ultimaker 2 with a plain white filament. The turtle was printed without support but the Jekyll character and Joker needed a bit of support and cleanup. i didn't treat the surface after the print, the white plastic is not very glossy, so it hides the ridges well
@Spiffy Exciting times to be a 3D artist! Those aren't printed at highest resolution either
The Joker straightjacket print is about 12 cm in height, the Joker head in goldish filament is 7cm. Not sure about the turtle head, but it would fit in the palm of your hand
Replies
They look great btw
@Spiffy Exciting times to be a 3D artist! Those aren't printed at highest resolution either
Here it is in progress on the Ultimaker