[PAINTER] Settings reset when switching between tools/particles/etc?
polycounter lvl 8
Hi all,
I've been running into a little frustrating issue when trying to paint some particle effects. My process has been to create a new layer, set up a material that I want to use, select the particle I want to use, and then go at it. However, when I clicked on the eraser to remove some of the work, I seem to have lost the modified material I made. I have to click on bullet impact or something else to get it out of eraser mode in the properties, even though my particle brush is selected. Once I kind of finally get back to where I was at, I have to recreate the modified material.
Is there something that I am missing when switching between these modes or just missing in general?
Thanks!
I've been running into a little frustrating issue when trying to paint some particle effects. My process has been to create a new layer, set up a material that I want to use, select the particle I want to use, and then go at it. However, when I clicked on the eraser to remove some of the work, I seem to have lost the modified material I made. I have to click on bullet impact or something else to get it out of eraser mode in the properties, even though my particle brush is selected. Once I kind of finally get back to where I was at, I have to recreate the modified material.
Is there something that I am missing when switching between these modes or just missing in general?
Thanks!
Replies