thank you, I can't remember if i did a drawing. I think i just put two wheels down and made a body for the bike. after that all i had to do was put in the list of parts it needed.
the rider, well she is being blocked out and a bit rough at the moment. plus i really want to finish the bike before i give her my attention.
there are a few infuances for this bike but i knew what it looked like before started. so almost all of it was 3d concept, over a very short period of time . the block out took not more than a couple of hours.
Replies
Did you do any sketching or did you just start concepting in 3D?
And what are your plans for the rider?
the rider, well she is being blocked out and a bit rough at the moment. plus i really want to finish the bike before i give her my attention.
there are a few infuances for this bike but i knew what it looked like before started. so almost all of it was 3d concept, over a very short period of time . the block out took not more than a couple of hours.