Snapping the of an object in 3ds max
polycounter lvl 9
Hey Polycount,
I was just wondering if there was anyway that I could make it so that I can align everything to face the same direction?
The red lines show the direction of the objects and I need them to ideally snal to 90 degrees.
To put this problem in context , the wire frames are the foot of a mech that I have made, which needs to transform into a vehicle which would need good alignment for the wheels etc so they don't look like they are falling off. Due to the change in design and the need to collapse stacks , reset xforms and pivots etc, which sucks.
Any help on this would be greatly appreciated
Thanks
I was just wondering if there was anyway that I could make it so that I can align everything to face the same direction?
The red lines show the direction of the objects and I need them to ideally snal to 90 degrees.
To put this problem in context , the wire frames are the foot of a mech that I have made, which needs to transform into a vehicle which would need good alignment for the wheels etc so they don't look like they are falling off. Due to the change in design and the need to collapse stacks , reset xforms and pivots etc, which sucks.
Any help on this would be greatly appreciated
Thanks
Replies
If so, the Normal Align tool immediately comes to mind.
[ame="