How to handle that?

Gazu

Hi PC!

This is a Camera Display and the right side has a hard corner.
I need a hard corner on the left side too.
But i cant add a swift loop or some cuts because the left side of the camera body gets hard.
And i dont want to have roundness with hard edges.
What can i do here ? It´s a box rounded up on the left and right side.


Edit:
Here a better picture:

ivanzu

Can you post a picture of the whole model and reference image,wireframe would be good too.

Gazu

Here are the Wires without TS:


Top View to see where the display starts:


And the back:

ivanzu

I figured it all wrong:D

Just do what the person below said.

Dismembered

The short answer, is add more geo around the curve when you initially created it. Shapes that need smoothing like this often come up in the sticky up top, here.

Gazu

Ivanzu:
No problem

A box with a lot of sides?
Will that work because the left and the right side are stretched to get the shape of the camera body.

ivanzu

Try this.

Gazu

I have tried a Edge Loop around this corner. But it comes out a little bit unclean!
Thanks anyway!
And now i made a new Box and i think that this is good:


Just have to align it a bit better ^^

ivanzu

Looks good and probably is going to be much easier to work with unconnected piece.

Gazu

Thanks!
Yeah, now i can move on to get the high poly finished.

Sorry!
I shouldnt open a new thread. I could work with a new Piece of Geometry from start.

But the objective is an 200 Sides Cylinder and the smoothing works great