Hi guys Im Erick, and wated to share some of my artwork as well as to receive a good critique. This is my LP SALVAGE MOE-B with 5780 POLYS. my maps are 4096X4096.
It's hard to get the full scope of the model from this angle. Do you have front 3/4 and rear 3/4 shots?
5k tri count seems reasonable on a vehicle, but it's hard to tell without wires. Do you have a wire render?
And 4k maps seem like it could be a tad large for this. Hopefully this is all one map? I usually drop my maps down a size, use the "Sharpen>unsharp mask> 50pts" on my diffuse and spec and check the results. Have you tried decreasing the size of those maps?
Thank you much for the feed back, I do have different shots on my website HERE and a turnaround done in marmoset I believe I can go down on the tires and get rid of some polys.
Thank you here is an screengrab from MAX showing wires, it also looks like there is a seem but that is because of MAX's viewport. You should check out my website too.
Replies
5k tri count seems reasonable on a vehicle, but it's hard to tell without wires. Do you have a wire render?
And 4k maps seem like it could be a tad large for this. Hopefully this is all one map? I usually drop my maps down a size, use the "Sharpen>unsharp mask> 50pts" on my diffuse and spec and check the results. Have you tried decreasing the size of those maps?
Thank you here is an screengrab from MAX showing wires, it also looks like there is a seem but that is because of MAX's viewport. You should check out my website too.
erickmartinez3dartist.com