ZBrush Artifacts and Symmetry

Rai

I'll start off with a 100% symmetrical model, enable Dynamesh, sculpt a little bit and use Auto Re-Sym, it creates small artifacts in the mesh and the symmetry goes down to about 99.8%.

This is with or without masking half of the model as well.
Local Symmetry is on, not sure if that helps or changes much with Auto Re-Sym.

Pretty irritating, what am I doing wrong?

cryrid

Use mirror and weld to keep the detail and topology symmetrical after dynameshing. As for the artifacts, what do they look like?

Rai

I'm not at the PC at the moment, so I can't really take a picture.. But they seem to be single verts that are stretched halfway into the model, sometimes small rows of them will be stretched somewhere to their extreme.