Modo 10v2:- manipulating meshfusion bevels
polycounter lvl 9
I'm currently following a tutorial by Simon Fuchs (Blizzard) who uses meshfusion. I felt this this was a great opportunity to speed up my workflow. It appears Fuchs is using an older version of Modo not that should really matter. I follow the tutorial introduction and make a simple 'subtract others from first selected' operation
Once I am able to manipulate the strip I go to 'new width size' and try to change the size of my bevel and for some reason it appears to be constraint and will not go any any further, and even at that point the bevel is very very small.
Any help would be greatly appreciated. Thank you.
Once I am able to manipulate the strip I go to 'new width size' and try to change the size of my bevel and for some reason it appears to be constraint and will not go any any further, and even at that point the bevel is very very small.
Any help would be greatly appreciated. Thank you.
Replies
I have manged to figure out my problem, all due to just bad scaling between 3ds max and Modo. I'm now just using 10.1v2 as its the closest to what Simon Fuchs is using and yeah considering 10.2 is just completely different.