[MD] - Can't change Sewing Line Type (Turned, flat)
polycounter lvl 5
Hello
Can you guys figure out what is wrong with this.
I'm trying to change the "Sewing Line Type" from "Turned" to "Flat". But MD for some reason is not allowing it.
Here is the full scenario.
I'm creating a fabric that needs to have both side. So after creating the first pattern I used "layer clone". It creates an instanced pattern with seams but with reversed normal.
Now I'm attaching a similar pattern over it for the wrinkling.
Check the image
http://i.imgur.com/KC2F3vR.jpg
I don't know how to deal with this.
Can you guys figure out what is wrong with this.
I'm trying to change the "Sewing Line Type" from "Turned" to "Flat". But MD for some reason is not allowing it.
Here is the full scenario.
I'm creating a fabric that needs to have both side. So after creating the first pattern I used "layer clone". It creates an instanced pattern with seams but with reversed normal.
Now I'm attaching a similar pattern over it for the wrinkling.
Check the image
http://i.imgur.com/KC2F3vR.jpg
I don't know how to deal with this.
Replies