Hey friendo. You're gonna learn some math here, sorry. I see you didn't get the help needed, so here's a lesson in patterns. Identify the largest repeatable pattern. In this case, i'm able to pizza this boi into 6 pieces. The base angle for this pattern found by 360°/6=60° Now to break down one of these 60° slices. I do…
What I'm trying to say is: The stack is not pivotal to the way I work. I mean the actual assembly of modifiers subsequently building off of each other. Modifiers themselves are a huge part of my workflow, and I view them as time saving operations to be committed to the model, nothing more. I'm not sure what our disconnect…
@vakdlfjas Welcome to Polycount. Consider checking out the forum information and introduction thread. Placing support loops along the edges that make up the walls of a cylinder will causing pinching. The topology needs to be routed around the existing cylinder geometry so it doesn't interfere with the smoothing behavior at…
@ANAFREE Aregvan is correct: the smoothing artifact is caused by overlapping geometry and modeling this type of surface detail as a separate piece of floating geometry will be more efficient than trying to blend everything together into a watertight mesh. There's an extra edge loop that runs between the primary support…
@Daf57 The base geometry that's controlling the subdivision isn't dense enough to support the perforations. For that to work the mesh would have to be subdivided to an appropriate level before the perforations are added. There are several alternatives that will look better, work better and require less effort. If the model…
@PleaseHelpMe A few posts up there's a couple of discussions about adding shapes to curves. You'll want to read through those for a more detailed answer to why this is happening and how to resolve it but the basic idea is to maintain a relatively consistent spacing on the geometry that makes up the curved surface and use…