When I use an IMM Curve Brush in ZBrush to create a decorative pattern, I scale the inserted mesh using size graph in curve modifier tab. But from the side view, I can see that the scaling is based on the center of the IMM mesh, not the bottom of it so when I scale it down, the mesh ends up floating above the surface.
Is there a way to set the pivot or gizmo of the IMM mesh to the bottom of the mesh, so that it scales toward the surface and stays attached properly when resizing?
Replies
(I searched the interwebs for "IMM Curve Brush in ZBrush pivot" to find it)