The BRAWL² Tournament Challenge has been announced!
It starts May 12, and ends Sept 12. Let's see what you got!
https://polycount.com/discussion/237047/the-brawl²-tournament
It starts May 12, and ends Sept 12. Let's see what you got!
https://polycount.com/discussion/237047/the-brawl²-tournament
Zbrush problem one side model
polycounter lvl 2
Hi all.
I was just doing my sword, I done masking and extract it but for now my extract have only one side and close holes don't work I was trying to find an answer for that on YT, but first time nothing seems to work.
Thanks for any advice.
Thank you for any advice on how to fix it.
Replies
Make sure that these meshes are actually one-sided, and not merely a super thin model, since the display of Backfaces is normally turned off by default.
You can find it under Tool: Display Properties
If Double is turned off, then this is just a really thin double-sided mesh, and not an open one. If this is the case, try creating some polygroups based on normals, so that you can isolate the faces on the back side. From there you can either try using masking and scaling to flatten them, or delete them and then start closing the holes (this method might require more manual work due to the smaller, fancier shaped islands).
Thank you for a nice idea, yes this is a super thin model And I will need to give it some love now.
+1 :)