The BRAWL² Tournament Challenge has been announced!
It starts May 12, and ends Sept 12. Let's see what you got!
https://polycount.com/discussion/237047/the-brawl²-tournament
It starts May 12, and ends Sept 12. Let's see what you got!
https://polycount.com/discussion/237047/the-brawl²-tournament
Cylindrical cut - strange shading
polycounter lvl 4
Hello, i need your help.
I created a cylinder and cut a box shaped hole.
When i fixed the topology and rendered, i noticed this weird shading problem.
Any ideas, what to do?
Thankss.
In Viewport
In render
I created a cylinder and cut a box shaped hole.
When i fixed the topology and rendered, i noticed this weird shading problem.
Any ideas, what to do?
Thankss.
In Viewport
In render
Replies
Your corner consists of four edges, but only two go all around the cylinder, this creates a pinch.
I would extend all horizontal edges around the cylinder and would see if I can also put the vertical edges the whole way down.
This will probably create some pinch in the cylinder, too, but with a little bit tweaking (while "show end result" is active) you should be able to reduce it.
Also rember depending on the scale of the object and where it is in your model (and what the model is for) not everything has to be 100% clean/correct.