How to sharpen after dyna-meshing

deolol · Jun 2012

Hi i use dyna mesh all the time now, but its always low resolution what is a good technique to make everything high res/crisp and sharp, because all major forms are done on dynamesh i dont know the process afterward

Thanks

SkulkerGray · Jun 2012

Under the Dynamesh button turn up the resolution slider to something around or above 512

Or leave dynamesh and just use the divide button from there is what i usually do

Computron · Jun 2012

reproject. It's right next to the dynamesh button.

|MM| · Jun 2012

Depends on what exactly you want to sharpen.
As previously said to get the most of sharp detail use

Also to sharpen the overall form a bit you can use Inflate deformation with a negative value.

deolol · Jun 2012

ty guys

BeatKitano · Jun 2012

Playing with the polish settings and activating it in the dynamesh section may help.
It tends to somehow change some details but it can help to get crisp edges in the roughing stage (before dividing up)

How to sharpen after dyna-meshing

Replies