Blurring maps in 3ds max?

Replies

• 
  Offline / Send Message

  SyncViewS polycounter lvl 13

  Feb 2010

  Hi, I'm not on Max 2010, but should be the same. In the Bitmap map type, you got a Blur parameter (rollout: Coordinates, on the lower left corner) you can define for every image file. It is set to 1.0 by default, if you increase it, the map will be blurred in render.

  0 · Share on FacebookShare on Twitter
• 
  Offline / Send Message

  System admin

  Feb 2010

  Did you mean a material type that allows blurring of all sub maps, like a global control? Haven't seen anything like that but you can use blur and blur offset in all map slots of a shader.
  

  0 · Share on FacebookShare on Twitter
• 
  Offline / Send Message

  ultramedia polycounter lvl 18

  Feb 2010

  I'm using the tile map to mask different regions in my terrain heightmap (using it in brick mode with holes). The warp map lets me randomize the edges so they don't look so square, but they're still very hard. Unfortunately the blue on the tile map doesn't work very well...

  0 · Share on FacebookShare on Twitter
• 
  Offline / Send Message

  Eric Chadwick admin

  Feb 2010

  Painting a mask by hand will take you much less time than fiddling with a procedural mask like Tiles, and you'll get better results IMHO. You can also then use the Blur Offset to soften it if you like.

  0 · Share on FacebookShare on Twitter