Introduction and a female WiP

Gurahl

Howdy,
I've been a lurker at Polycount for a long time now, there is a lot of inspiring work here and plenty of useful information. Which is to say thanks to all of the posters here.

Anyway, I recently decided to take a more active role in developing my work, and am looking to

a) show off a little (not that I can compete on quite the same level as some here)

and

b) get some comments and criticism

Anyway, I have the beginnings of a portfolio happening at
my portfolio page and have also posted this peice at 3d campfie which is a startup board for 3d and digital work in Australia in particular.

So onto the pics.







Gurahl

Gmanx

Try

KDR_11k

No, on Polycount it's [image]. However, you should add the http:// bit to the front.

MoP

IMG works too, KDR
Edited the OP to fix the links.

Gurahl

Thanks for the info, I think what I did was ok for the images, at least they displayed no probs here...

Which vertical edge do you mean btw? the central one is at least partly there because there is still a symmetry modifier on the model, though I can't see much that could be done to remove it. The edge edge central to her breast needs to be there to flesh out the torso and stop it being a diamond shape (from above)...

Gmanx

I meant the central vertical edge going from the bottom of her sternum to her naval area. It just looked oddly long, like it needed dividing, or the verts moving closer together. BTW I can't see the pics at all now.. the links are broken.